|
How to Create a Snapshot With the Oracle ILOM Command-Line Interface
Posted by Rizki Amar Kuswara, Last modified by Sandi Widianto on 16 November 2022 03:16 PM
|
|
Before You Begin
To collect SP data using the Service Snapshot utility, you need the Admin (a) role enabled.
- Log in to the Oracle ILOM CLI.
- Type the following commands:
->set /SP/diag/snapshot dataset=data
->set /SP/diag/snapshot dump_uri=URI
where data and URI are one of the following:
|
|
|
|
|
data
|
normal
|
Specifies that the Oracle ILOM, operating system, and hardware information is collected.
|
|
full
|
Specifies that all data is collected (“full” collection).
Note - Using this option might reset the running host.
|
normal-logonly or
full-logonly
|
Specifies that only log files are collected.
|
|
URI
|
Any valid target directory location
|
Specifies the URI of the target directory. The URI format is as follows: protocol://username:password@host/directory
where protocol can be one of these transfer methods: SFTP or FTP.
For example, to store the snapshot information in the directory named data on the host, define the URI as follows: ftp://joe:mypasswd@host_ip_address/data
The directory data is relative to the user login, so the directory would probably be /home/joe/data.
|
|
The snapshot places a zip file in the specified URI.
- Unzip the file to access the data produced by the snapshot
|
 (0 vote(s)) Helpful Not helpful
|
